---------- Forwarded message --------- 发件人： <gem5-users-owner@gem5.org> Date: 2023年5月8日周一 21:21 Subject: How to warm up the simulator during garnet 3.0 simulation while using the Garnet_standalone protocol. To: <lichunfeng.bit@gmail.com> Your message to the gem5-users mailing-list was rejected for the following reasons: The message is not from a list member The original message as received by Mailman is attached. ---------- Forwarded message ---------- From: Chunfeng Li <lichunfeng.bit@gmail.com> To: gem5-dev@gem5.org, gem5-users@gem5.org, gem5-announce@gem5.org Cc: Bcc: Date: Mon, 8 May 2023 21:21:32 +0800 Subject: How to warm up the simulator during garnet 3.0 simulation while using the Garnet_standalone protocol. Dear Friend， When I try to test on-chip network latency using the garnet 3.0 emulation simulator in gem5, I don't know how to warm up before emulation. If I don't warm up the emulator, it will produce incorrect results. So, if you know how to warm up the emulator, I would also appreciate it if you could reply to my question! Best regards